Construction technology of toilet partition:
1. On site inspection: check the copy size of the drawings, check whether the drawings meet the requirements, check whether the ceramic tiles, sanitary ware and other related finished products are damaged, and carry out special process construction according to the construction drawings confirmed by Party A and the supervisor.
2. Setting out: locate and mark the wall size and keep it horizontal. Vertical and large area areas shall be set in the middle of two pits or operate as required.
3. Installation elevation: check the elevation and size of partition installation in the toilet according to the measured drawings.
4. Installation and positioning: according to the elevation, the hardware hinges, door locks, handles, supports and beams confirmed by the designer and the supervisor are designed and passed. When using the safety bracket, the distance between both sides is the same. When there is a large right angle, it ensures that it is in the middle, and the upper and lower ends are kept at 20 cm. There are pipes according to the situation. Measure the waistline and then open it. The seam shall not exceed 0 or 1cm right angles. Be careful not to break wall or floor tiles. When installing hinges, the upper and lower ends of the door shall be kept at about 20cm, and the lower end of the door shall be consistent with the height of medium and small parts. Before using the screws, the hinge screws should be installed, and the depth should be controlled within 1 cm. When locking, pay attention that if there is a trapezoidal lock cylinder, its position is 85CM away from the lower end of the door; If there is a groove used by the disabled, it shall be parallel to the position with step lock; The ingot beam shall be fixed on the small and medium pieces with screws or nails; The plastic plate or aluminum sheet of the ingot shall be fixed in the installation position with round head screws; On the back, note that the plastic plate and lining shall be seamless and flat.
5. Installation and commissioning: the distance between the door seam and the outrigger shall be 2-2 and 5mm, and at least two screws shall be fixed. The bottom of the door body should be flush with the bottom of the middle section to make the door easy to open and return to the appropriate position. The isolation door shall be flush on all sides, and the door shall be horizontal and vertical from top to bottom, meeting the requirements of construction specifications.
6. Cleaning and gluing: when gluing, draw a line from top to bottom with the same thickness. There is no excess glue at the right angle. Its function is to ensure the firmness and sealing between the partition wall and the wall.
7. After installation, special personnel shall be assigned to prevent other construction teams from damaging products during operation.
8. Installation acceptance: we will conduct self inspection on the partition of the installed toilet and submit a report to the supervisor and Party A.
The above is the knowledge brought to you today. Jinan toilet partition has focused on the industry for many years and continuously provides users with valuable content. Please continue to pay attention to us for more content: http://www.jnndjc.com