1. wall fixing piece; Draw the center line of the fixing piece on the wall, drill three holes on the line with an electric drill, embed the plastic plug in the hole, and then fix the fixing piece on the wall with expansion screws.
2. Adjust the foot seat; Draw the center line of the position of the adjusting foot base on the floor, and fix the adjusting foot base on the floor 150mm away from the front edge of the compartment board.
3. diaphragm room; Stand the compartment board against the wall fixing plate and the adjusting foot base, raise the board to the ground, with a normal height of 145mm. After confirming the level, fix the compartment board on the wall fixing plate and the adjusting foot base with screws.
4. column; Center column - fix the pull rod fixing piece with screws on the top of the center of the column, as shown in Figure 4 above. Use L-shaped fixing piece to fix the column and compartment board into one. Wall column - draw a straight line perpendicular to the ground on the wall, use an electric drill to drill 3 holes on the line, embed the plastic plug in the hole, and use screws to fix the wall column with L-shaped fixing piece on the wall 145 above the ground after confirming that it is perpendicular to the ground.
Terminal column - fix the upper edge pull rod fixing piece and L-shaped edge connecting piece on the terminal column, and then fix the plate on the compartment plate with screws.
5. Pull rod; 1) Cut and fix according to the actual length of the compartment. When the straight-line pull rod is flat connected, a circular connecting sleeve and an urgent connecting spring sheet must be installed in the pipe to confirm that the joint is flat and firm, and the joint shall be in the upper tension fixing sheet to add beauty.
2) For the 90 degree corner pull rod of the compartment, the 90 degree corner joint formed by aluminum alloy injection is used to connect the pull rods at both ends of the corner.
3) Fix the sleeve on the convex wall, and fix the terminal pull rod on the wall with screws.
4) Use screws to connect and fix the pull rod with the fixing plate on the upper edge of the column.
6. Door leaf; The upper and lower parts of the safety hinge seat are fixed on the column, and the hinge sheet is fixed on the upper and lower parts of the door leaf. The active homing nylon seat is placed in the hinge seat, which can make the door leaf open and close freely according to the viewpoint we need.
7. safety indicator lock; When the safety indicator lock is fixed on the column and no one is using it, the indicator lock will show green, and when the lock is closed, it will show red. In case of emergency, the safety indicator lock can be opened from the outside to facilitate the urgent needs of safety.
The wonderful content of this article is provided by Jinan toilet partition. There are many wonderful content on this website. You can click to enter more content http://www.jnndjc.com We have special customer service to answer your questions