Construction preparation of toilet partition
1. Materials and installation tools:
(1) The style, quantity and processing quality of diaphragms entering the site shall meet the design requirements, and the factory certificate shall be provided.
(2) The type, specification and model of hardware fittings shall meet the requirements of the drawing, match with the toilet partition, and the product quality shall be qualified.
(3) Installation tools: electric hammer, screwdriver, electric drill, screwdriver, etc.
2. Operating conditions:
(1) The toilet partition must be inspected and accepted when entering the construction site. Before installation, check whether the model and size meet the requirements.
(2) The on-site installation team implements the team leader responsibility system, and the team leader is responsible for overall planning and coordination of matters during construction.
(3) Strictly follow the construction procedures to ensure the construction quality.
(4) Pay attention to the opening direction and measured dimension of the toilet partition door panel to ensure the cutting direction of the door during installation.
Key points of toilet partition construction
(1) On site inspection: check the size of the drawing, check whether the drawing is consistent with the site, and check whether the finished products related to ceramic tiles, sanitary ware, etc. are damaged. For special processes, the construction shall be carried out in accordance with the construction drawings confirmed by Party A and the supervisor.
(2) Setting out and positioning: mark the wall size, keep it horizontal, and install the vertical and large area in the middle of the two pits (or operate according to the site requirements).
(3) Installation elevation: check the elevation dimension of toilet partition installation according to the measured drawings.
(4) Accessory positioning:
According to the elevation, the hardware (hinge, door lock, handle, support and cross beam) confirmed by the designer and the supervisor has passed the design confirmation. When installing the support, the spacing between the two sides shall be the same. When installing the large right angle, ensure that it is in the middle position (in the middle), and the upper and lower ends shall be kept at 20cm (in the center of the right angle) with pipes as the case may be.
The waist line shall be measured and then opened. The seam shall not exceed 0.1 cm (right angle). Be careful not to damage the wall or floor tiles. When installing the hinge, the upper and lower ends of the door shall be kept at 20 cm, and the lower end of the door shall be the same as the height of the small and medium-sized pieces. The hinge screws shall be installed at (the depth shall be controlled at less than 1 cm when drilling holes, and then the screws shall be installed.
When installing the lock, it shall be noted that if there is a step lock cylinder, the position shall be 85CM from the lower end of the door. If there is a pit for the disabled, it shall be parallel to the position of the step lock. The lock must be upright and flexible. The spindle beam shall be fixed with screws or nails on the small and medium pieces. The spindle plastic plate or angle aluminum shall be fixed with round head screws from the opposite side. It shall be noted that the plastic plate and the small and medium pieces are seamless and flat.
(5) Installation and commissioning: adjust and fix the door seam at a distance of 2 to 2.5 mm, fix at least two screws at the lower leg, make the door flush with the lower end of the small and medium-sized plate, make the door open easily and return to the position, align the four sides of the partition door with the line, make the door horizontal and vertical, and meet the requirements of the construction specification.
(6) Cleaning and gluing: when gluing, the upper and lower lines shall be the same in thickness. There is no excess glue at the right angle. Its function is to ensure that the partition and the wall are more firm and sealed.
(7) After installation, special personnel shall be assigned to take care of the product to prevent other construction teams from damaging the product during operation.
(8) Installation acceptance: after the installation of Jinan toilet partition, we will conduct self inspection and report it to the supervisor and Party A for acceptance after passing our inspection.
The above is the relevant answers to the questions. If you want to get more relevant information, please follow our website http://www.jnndjc.com Come on!